Page 20
When the odometer reaches the service alarm point, the
words “DISTANCE” and “ALARM” will begin to flash on and
off in the Current Readings, Driver ID Code Entry, and
Odometer screens.
You have the following options from the Odometer Screen:
❏
Clear the Service Alarm
To clear the service alarm once it has been
activated, press and hold SET/CLEAR for at
least 2 seconds, until the word “DISTANCE”
stops flashing. When you clear the service
alarm, the unit saves the time at which it
was cleared to memory (you may view this
information from the DriveRight Vehicle
Management Software) and loads the next
service alarm mileage point, if there is one.
Limits Screen
The Limits screen enables you to view the set speed, acceler-
ation, and deceleration limits for this Trip 500AL unit. You
may not change any of the limits from this screen; limits
may only be changed from the Limits and Units Setting
screen (see “Time Entry” on page 27), or using the Drive-
Right Vehicle Management Software.
Acceleration and deceleration is measured in “G’s” (the
gravitational constant which represents the acceleration of
an object when falling to earth in a vacuum). 1G is roughly
equal to an acceleration of 35 km/h (22 MPH) per second.
Limit Settings Screen
km/h
ACCEL
G
G
DECEL
SETTINGS
SPEED
Speed Limit
Deceleration Limit
Acceleration Limit
