Product Numbers: 7768
Davis Instruments Part Number: 7395-107
Small Surge Protector Shelter
Rev. A Manual (7/8/99)
This product complies with the essential protection requirements of the EC EMC
Directive 89/336/EC.
© Davis Instruments Corp. 1996. All rights reserved.
9. Repeat this procedure for each colored wire.
10. If attaching shielded cable, loosen the top hex nut on the mounting post (where the
Surge Protectors are held in place) and place the bare drain wires from each cable
between the two flat washers, bending the wires around the screw post.
The drain wires go in the same location as the ground wire (see “Attaching
Surge Protectors” on page 3).
11. Tighten the top hex nut on the mounting post until the drain wires are secured.
A
TTACHING
W
IRES
TO
THE
S
URGE
P
ROTECTORS