DAVIS Surge Protector Shelter (Small) User Manual Download Page 1

 

Product #7768

 

S

 

M A L L

 

  S

 

U R G E

 

 

P

 

R O T E C T O R

 

 

S

 

H E L T E R

 

The weather-resistant Small Surge Protector Shelter (simply referred to as the 
shelter in this manual) provides protection from the elements for Surge Protec-
tors when located outside. The shelter can accommodate one or two Surge Pro-
tectors, protecting two to four wires.

 

CAUTION:

 

Please note that we have made every attempt to provide a safe product, but Davis Instruments 
assumes no liability for any injury or damage caused directly or indirectly by the installation or 

 

use of this product.

 

C

 

OMPONENTS

 

Please make sure that you have listed components before continuing.

 

 

Enclosure

 

 

Two #10-32 Brass Hex Nuts

 

 

Two Flat Washers

 

 

Locking Washer

 

 

Two #8 x 

 

 

” (19 mm) self-tapping screws

Summary of Contents for Surge Protector Shelter (Small)

Page 1: ...ne or two Surge Pro tectors protecting two to four wires CAUTION Please note that we have made every attempt to provide a safe product but Davis Instruments assumes no liability for any injury or damage caused directly or indirectly by the installation or use of this product COMPONENTS Please make sure that you have listed components before continuing Enclosure Two 10 32 Brass Hex Nuts Two Flat Wa...

Page 2: ...TER You may mount the shelter against a wall or other vertical surface or you may simply lay it down on a horizontal surface The preferred mounting method is to mount it on a vertical surface in a protected location with the rubber grom met facing down Note You may install the wires through the grommet and into the terminal blocks before or after mounting the shelter 1 Hold the shelter against the...

Page 3: ...nector off if using standard cable stripping 1 25 mm of the jacket the outer covering and the shield the foil like inner covering on shielded cables from each cable and stripping 12 5 mm of insulation the colored covering from each individual wire 3 Loosen both hex nuts on each post of the Surge Protector Loosen the top hex nut as far as possible loosen the bottom hex nut about half way along the ...

Page 4: ...e for each colored wire 10 If attaching shielded cable loosen the top hex nut on the mounting post where the Surge Protectors are held in place and place the bare drain wires from each cable between the two flat washers bending the wires around the screw post The drain wires go in the same location as the ground wire see Attaching Surge Protectors on page 3 11 Tighten the top hex nut on the mounti...

Reviews: