4
© 2020 Davis Packaging : DPM39-0320ARef
Setup and Film Loading
1. Position unit on a flat level surface. Adjust feet (A) as needed to eliminate rocking.
2. Place film roll on top of Film Rollers (B) so that the Film Unwind (C) is coming from
bottom of roll towards front of unit and over Film Retaining Rod (D), and slightly past
Guard Lever (E).
3. Plug unit into 110 v - 120 v power source and flip Power Switch (F) on to heat Cutting
Rod (G) (approx. 3-5 mins). Rod is fully heated when film easily cuts.
4. Grasp sides of film from behind Film Retainer Rod (D) and simultaneously pull
forward and press down on Guard Lever (E) to cut excess film and create a clean
start line.
5. Adjust Film Tension Screw (H) until a slight drag is felt when pulling film to prevent
film roll from over spinning and sticking to itself. Loosen Film Tension Screw if film is
difficult to pull or rips when pulling.
6. Plug Optional Accessory Hand Iron or Hot Plate into Accessory Outlet or extension
cord. Turn on accessory and allow to heat (3-5 mins). Adjust thermostat knob until
Iron or Hot Plate is hot enough to seal film seams without melting holes in film. Turn
knob clockwise to increase heat and counter-clockwise to lower heat.
P: 800.622.3015 / 561-290-0412 □ E-mail: [email protected]
www.davispackaging.net
(E) Guard Lever
(D) Film Retainer Rod
(B) Film Rollers
(C) Film Unwind Direction
(H) Tension Screw
(A) Adjustable Feet x 6
(F) Power Switch
(G) Cutting Rod
