Tools and Materials Needed
Page 2
Tools and Materials Needed
You may need the following for this installation:
✦
Adjustable Wrench or 5/16” Wrench
✦
Flat Head Screwdriver
✦
Pliers
✦
Wire Cutters or Scissors
Installation Guidelines
✦
The power cable supplied is six feet (6’, 1,8 m) long. Mount the Second
Panel close enough to your EZ-Solar Power shelter for the power cable
to reach without stressing the power cable connections.
✦
Refer to the EZ-Solar Power Kit manual for complete mounting
instructions.
Connecting the Cables
1.
Open the EZ-Solar Power shelter
door using a flat head screw-
driver.
2.
Disconnect the red/white wire
from the positive (+) battery ter-
minal.
3.
Disconnect the black wires from
the negative (-) battery terminal.
4.
Install the Y-terminal adapters on
the battery terminals. It is a tight
fit, so you might want to use pliers
to push the Y-terminal adapters onto the battery terminals.
5.
Connect the red/white wires from the regulator to the Y-terminal adapter
on the positive (+) battery terminal.
6.
Connect the black wires from the regu-
lator to the Y-terminal adapter on the
negative (-) battery terminal.
7.
Remove one round vent plug from the
bottom of the EZ-Solar Power Panel.
8.
Run the EZ-Solar Second Panel power
cable up through the power panel vent
hole.
9.
Press the power cable’s vent plug into
the vent hole until it locks into place.
Y-terminal adapter installed on negative battery
terminal
Running the Second Solar Panel power cable
into the EZ-Solar Power shelter
