8
3. Swivel the ane-
mometer until the
arm is pointing
north, if possible.
4. Using an adjust-
able wrench or
7/16" wrench,
tighten the nuts. If
the anemometer
arm is not point-
ing north, follow
the instructions in
Appendix A in
your ISS manual.
Mounting Anemometer on a Vertical Surface
1. With a 3/16" (5 mm)
drill bit, drill two holes
approximately 2-1/8"
(54 mm) apart. Use a
carpenter’s level to
ensure the holes will be
level.
2. Insert the 1/4" x 3" lag
screws through the flat
washers and the holes in
the mounting base into
the post.
3. Using an adjustable
wrench or 7/16"
wrench, tighten the lag
screws.If the anemome-
ter arm is not pointing
north, follow the
instructions in Appen-
dix C in your ISS man-
ual.
U-Bolt
1/4" Flat Washer
1/4" Lock Washer
1/4" Hex Nut
1/4" Flat Washers
1/4" x 3" Lag Screws
40' of Anemometer Cable
