DaVinci LED Power Supply
sku# 250-05849
Page 3 of 3
17602224 - 9/13/2021
© Travis Industries, Inc.
Installation - (Current Fireplace)
1. Gain access to the component area of the fireplace (see installation manual for details).
2. Locate the LED power supply. Disconnect the Molex connector from the “power in” on the fireplace. Cut the
Red and Green wires just below the connectors. Remove and Replace the power supply.
3. Crimp the connectors included with this kit on to the red and green wires.
IMPORTANT
Crimp the
male
connector on to the
RED
wire and the
female
connector
on to the
GREEN
wire
IMPORTANT
4. Connect the RED and GREEN wires to the corresponding connectors on the power supply (RED to RED,
GREEN to BLACK).
POLARITY DOES MATTER. The RED
LED
wire to the RED power supply wire. The GREEN
LED wire to the BLACK power supply wire.
5.
Restore the fireplace to its correct configuration.
Cut the Red and Green wires
just below the connectors
Red
Green
Disconnect “Power In”
& discard
Red
Green
Red
Black
