Davin J012, Service Manual

Page: 54 / 365

5. Load the paper into the cassette.
6. Add paper until it as far as the load limit marks .
• To prevent paper jams, never load paper higher than the load limit mark.
7. Pinch the tabs of the bottom fence . Then move it to the edge of the stack.
8. Make sure the top of the stack is perfectly flat. Do this if the top of the stack bends upward:
9. Adjust the positions of the side fences and bottom fence.
10. Reattach the paper tray cover .
11. Slowly insert the paper tray into the machine.
12. Make sure that the paper tray is correctly inserted.
Do the Paper Type/Size Settings for Tray 2
1. [Menu]> "System Settings?"
2. [

] or [

] > "Tray Paper Setting?"> [Yes]> "Tray1?"
3. [  ] or [  ] > "Tray2?"> [Yes]> "Paper Type?"> [Yes]> "Plain Paper?"
4. [  ] or [  ] > Select the type of paper that will be loaded in Tray 2
5. [Yes] > "Tray Paper Setting?"> [Yes] "Tray2?"> [Yes]> "Paper Type?"
6. [

] or [

] > "Paper Size?> [Yes]
7. [  ] or [  ] > Select the size of paper that will be loaded in Tray 2
8. [Yes] > "Tray Paper Setting?"
9. [Clear Modes> Standby
10. Cycle the machine off/on.
Multi Bypass Tray J507
The multi-bypass tray is an option that can be installed on any J012, J013, or J014 machine.
Installing the Multi Bypass Tray
1. Make sure that the machine is switched off and disconnected from its power source.
2. Remove the multi-bypass tray from its box.
3. Remove all the orange shipping tape and plastic from the bypass tray.
Options
53
1