23
Amount:
-127…+127 —
Sets the amount of Envelope 3.
Env Velocity:
0…127 —
Sets the amount of key velocity controlling the level of
envelope 3.
Env Delay:
0…127 —
Sets a delay between the time Envelope 3 is triggered and
when the Attack portion actually begins.
Env Attack:
0…127 —
Sets the Attack time of Envelope 3.
Env Decay:
0…127 —
Sets the Decay time.
Env Sustain:
0…127 —
Sets the Sustain level.
Env Release:
0…127 —
Sets the Release time.
Repeat:
Off, On —
When on, causes the delay, attack, decay, and sustain
portions of Envelope 3 to loop for as long as the envelope is gated on.
Modulation Parameters
The Modulation Parameters let you configure the modulation routing and
amount for Tetra’s four general-purpose modulation slots as well as for MIDI
controllers (Mod Wheel, Key Pressure, Breath Control, Velocity, and Foot
Controller).
Since each Tetra mod source has a single destination, the four general purpose
Mods provide a way to send a mod source (such as a sequence or LFO) to
additional destinations, with a different amount. There are also additional mod
sources available here, such as Noise, allowing a wide variety of possibilities.
To configure a general-purpose modulation slot, select the appropriate
modulator (Mod 1, Mod 2, Mod 3, or Mod 4), and use the Source, Destination,
and Amount parameters to route the modulation as desired.
To configure modulation for a standard MIDI controller, select the desired
controller and amount, and then set the destination.
Source
—
Selects a modulation source. See
Modulation Sources
on page 39 for
possible sources.
Amount:
-127…+127 —
Sets the amount of modulation.
Destination
—
Selects a modulation destination. See
Modulation Destinations
on page 35 for a list of possible destinations.
