32
Miscellaneous Audio Parameters
Output Hack: 5 8
0…14
Trashes the output signal, quite rudely.
Distortion: 5 8
S
o0…99, i0…99
Amount of distortion. If set to
o00
to
o99
, the
distortion is after the analog filter and VCA, before the Delay. If set to
i
00
to
i
99
, the
distortion is before the analog filter, and only affects external input. There are two
separate distortions, one for each channel.
Note - there is a built-in noise gate that is enabled when distortion is not zero. If
you want to use the noise gate but without distortion, use a distortion setting of
i
01
(noise gate on input signal), or
o01
for a noise gate after the analog
electronics. The noise gate uses the Left channel signal level to gate both
channels.
Noise Vol: 8 5
0…100
The volume of white noise mixed into the filter. The same
amount goes into both channels.
Ext In Vol: 8 6
0…100
The volume of external audio input connected to Left In
and/or Right In.
Ext In Mode: 8 7
see table
Selects the external input mode:
Display
External Audio Input Mode
st
Stereo – the left channel in goes to the left channel, right to right.
l
Left – the left channel in goes to both channels (mono in).
R
Right – the right channel in goes to both channels (mono in).
spl
Split - A mono audio signal is input on the Left Input; a separate
control audio signal (for envelope follower, peak hold, and clock
source) into the Right Input.
Input Hack: 8 8
0…14
Trashes the external input signal, quite rudely. But, the
analog filter tames it nicely. A good way to mess up a clean stereo signal.
Summary of Contents for Evolver
Page 1: ...Evolver Operation Manual Dave Smith Instruments ...
Page 2: ......
Page 13: ...13 ...
Page 63: ......