10
ROTARY LASER LEVEL
OPERATION - LASER INSTRUMENT
ON/OFF
Press the power button to turn on the instrument. Once it’s on:
•
The instrument always starts up in automatic mode and begins self-levelling if it’s set up
within 5° range (horizontal or vertical). During self-levelling, laser beam flashes before it
starts spinning.
•
Once it’s self-levelled, laser head will start to spin, emitting a rotating laser beam pattern.
•
If the instrument is bumped or senses interference, the laser head will stop spinning
and re-level. Once unit has re-levelled, the laser head will begin to spin again, emitting a
rotating laser beam pattern.
•
If the instrument is outside of the 5° range, it will not level causing the laser beam to flash
continuously. Reposition your instrument within the range until the instrument can re-
level.
Note:
If the unit has been bumped or moved and the laser recommences spinning the instrument may not
be at the original level position. Please recheck your RL/datum point.
RPM SPEED CONTROL
Rotation speed can be controlled by pressing RPM button on the instrument. In automatic
mode, laser rotation speed starts at 600rpm. Adjust the speed from 600rpm - 0rpm - 60rpm -
120rpm- 300rpm - 600rpm.
SCAN MODE
The scanning mode allows the laser beam to emit only in a restricted radius forming a horizontal line within
180°. There are 5 levels to choose from: 0° - 10° - 45° - 90° - 180°.
•
Turn on the instrument and allow self level.
•
Press the SCAN button to active scan mode. Laser starts with 0° when entering scan mode.
•
Adjust the scan width by pressing scan button.
•
To move the scan line, utilise the rotation control buttons.
•
To exit the scan mode, press RPM button and the laser will begin to self-level and rotate
again.
ROTATION CONTROL
In scan mode:
•
Press the counter-clockwise rotation button to move the laser line to the left.
•
Press the clockwise rotation button to move the laser line to the right.
