Rev 0.11
Page G.703-6
Interface Parameter Detail (when G.703 is Active)
Representation
Type
Entry
Description
For Advanced I5 Option Only
IIP
Mode
Type
Selection
Read Only
Displays type of IP interface
present (I5, SnIP, etc.)
IIP IPAddr
192.168.100.1
Numeric
IP Address for Ethernet IP
Interface.
IIP
NetwrkMask
255.255.255.0
Numeric
IP Mask Address for Ethernet
IP Interface.
IIP
MACAddr
0080A800256C
Read Only Read Only
Allows read of fixed Interface
MAC Address..
IIP
Options
00007f
Read Only Read Only
Displays Ethernet IP Options
enabled
IIP
Version
021771-001-50
Read Only Read Only
Displays Ethernet IP Software
Version Number
IIP
Serial#
1000047
Read Only Read Only
Displays Ethernet IP Serial
Number
G703P1
TxMode
E1
Selection
1=E1
G.703/E1 interface Port 1
always active if G.703 IO
Mode selected.
G703P1
TxCode
HDB3
Selection
0=AMI
1=HDB3
Line Coding selection.
G703P1
TxFrame
PCM31-CCS
Selection
0=Full E1
1=PCM30-CAS
2=PCM31-CCS
Input Framing selection;
Full E1 = Unframed Mode.
G703P1
TxCRC4
Enable
Selection
0=Disable
1=Enable
Cyclic Redundancy Check for
error reporting.
G703P1
TxNx64k
512 kbps
Read Only
Nx64kbps fractional E1 rate
for Port 1 transmitter.
G703P1
DropMap
TS08-On
Selection
TSxx
– 0=Off, 1=On.
xx = 01 to 31.
Press Up/Down key to toggle
between Off and On. Press
Left/Right keys to change
Timeslot number. Press
enter to program all timeslots.
Used for FractionalE1 mode to
select which timeslots (1-31)
that are to be dropped from
the input E1 framed signal and
transmitted over the satellite.
Timeslot 16 not available in
PCM30-CAS framing.
G703P1
RxMode
E1
Selection
1=E1
G.703/E1 interface Port 1
always active if G.703 IO
Mode selected.
G703P1
RxCode
HDB3
Selection
0=AMI
1=HDB3
Line Coding selection.
G703P1
RxFrame
PCM31-CCS
Selection
0=Full E1
1=PCM30-CAS
2=PCM31-CCS
Output Framing selection
G703P1
RxCRC4
Enable
Selection
0=Disable
1=Enable
Cyclic Redundancy Check for
error reporting
G703P1
RxNx64k
512 kbps
Read Only
Nx64kbps fractional E1 rate
for Port 1 receiver.
