4
English
1. Press in the ball catch on the upper
handle and insert it into the lower
handle. Make sure that the ball
catch locates in the hole on
the lower handle.
Lifting a vehicle
1. Park the vehicle in gear and put the handbrake on. Vehicles with automatic gear
boxes should be put into
P
(Park) and the handbrake put on.
2. Close the release valve by twisting the handle clockwise as far as it will go.
3. Place the jack under the vehicle so that the saddle of the jack is centred under one
of the vehicle’s lift points (consult the vehicle’s handbook for guidance).
4. Pump the handle up and down until the saddle makes contact with the lift point.
Check to make sure that the saddle is centred correctly before continuing.
5. Pump the handle until the vehicle is raised to a height which enables an axle
stand to be positioned under a strong point on the vehicle (consult the vehicle’s
handbook for guidance).
6. Carefully lower the vehicle onto the axle stand by slowly twisting the handle
anticlockwise.
Operating instructions
Attaching the handle
2. Loosen the set screw in the handle
bracket on the jack.
3. Insert the handle into the bracket,
making sure that it fits into the square
valve release socket. Tighten the set
screw.
