Instructions For Table JD Waterfall
Page 9 of 11
3 End Access Panel - Adjustment, Install And Removal
Note:
The End Access Panel (BB) can be mounted flush or raised 1/2" to allow for cables to pass through from the floor.
3.1 To Flush End Access Panel
3.1.1 Using a #2 Phillips Driver, loosen the screws securing the Support Bracket on each side and lower it until the slots top out on the
screws and re-tighten. [Fig. 08]
3.2 To Raise End Access Panel
3.2.1 Using a #2 Phillips Driver, loosen the screws securing the Support Bracket on each side and lift it until the slots bottom out on the
screws and re-tighten. [Fig. 09]
3.3 End Access Panel Install
3.3.1 End Access Panels (BB) are magnetically attached. Use one hand to rest and hold the bottom edge on the Support Brackets while
using your other hand to rotate the top edge up until the magnets catch to secure the End Access Panel into place. [Fig. 10]
3.4 End Access Panel Removal
3.4.1 End Access Panels (BB) are magnetically attached. Grab and pull firmly the top edge with one hand while using your other hand to
hold and support the bottom edge to disengage. [Fig. 11]
