Datcon DT1364, Operating Instructions Manual

Page: 12 / 36

DT1364
12
20171206-V0
The opening procedure needs a screwdriver for slotted
screws
1. Push the upper opening lever of the housing with the
screwdriver end slightly (figure step 1.).
2. Draw back the upper part of the housing back cover, to
fix the opened position (figure step 2.)
3. Push the lower opening lever of the housing with the
screwdriver end slightly (figure step 3.).
4. Draw back the lower part of the back cover, to fix the
opened position (figure step 4.)
5. Draw back the cover as far as both of the DIL switches
can be seen (figure step 5.).
There is no need to use great force for pushing the opening
lever. Please do not exercise forces higher than necessary.
4.2. Setting up operating modes
The following figure shows the switch positions and the
operating modes:
Switch positions
Use a stylus or a pencil to change the switch positions.
SWx
1 2 3
input
→
output
wire broken
detection
wire short
detection
On
reverse yes yes
SW1 (Ch1), SW2 (Ch2),
SW3 (Ch3), SW4 (Ch4)
Operating modes
Factory setting
→
Off
normal no no
To use wire broken, wire short detection in a case of
contact input see
6.2. Connecting the detectors or
contacts to the inputs.