Datavideo NVS-40D, Instruction Manual

Page: 17 / 100

17
Chapter 4 Quick Start Guide-Connection and Setting
Before you start to use the NVS-40, it is very important that you have to connect all
necessary cables and to complete the network and HDD settings. Due to the fact that
the NVS-40 can only be controlled by the Web UI, the Web UI must be set after all
hardware connections and settings are done.
4.1 Quick Start Guide
Please follow following steps for quick connection and setting guidance of the NVS-40.
Step 1. Please connect a DC 12V power cord connected with an AC-DC adapter from
the NVS-40 DC 12V connector to the AC outlet.
Step 2. Please turn on the power switch of the NVS-40.
Step 3. Please connect four HDMI video input sources
or one SDI and three HDMI video
input signals from the external connected block cameras to the HDMI and SDI video
input connectors on the rear panel of the NVS-40.
Step 4. Please connect the public network to the WAN port of the router via an RJ-45
Ethernet cable.
Step 5. Please connect another RJ-45 Ethernet cable from the LAN port on the rear
panel of the NVS-40 to the router.
Step 6. Please connect an RJ-45 Ethernet cable from the LAN port for the router to
your PC/Laptop.
Step 7. Please set your PC/laptop in DHCP mode.
Step 8. Please download Datavideo IP Finder utility software “NVS-2X_IPFinder” on
the Datavideo official website www.datavideo.com or by scanning the QR code.
Step 9. Please unzip the zip file and Install the IP Finder utility software after
downloading.
Step 10. Open the IP Finder utility software and then the connected NVS-40 IP address
will be shown automatically. If the IP address does not show automatically, users can
click the Scan button to find the IP address of all connected NVS-40 devices.