Datavideo NVS-40D, Instruction Manual

Page: 40 / 100

40
5.5.2 Streaming-RTSP (Use RTSP Protocol)
The NVS-40 allows users to stream by using the RTMP, RTMPS, RTSP, TS and HLS
streaming protocols. For the steps for streaming by those protocols, please see
following paragraphs.
1. Please use an RJ-45 Ethernet cable to connect one end to the public network and
then connect another end to the WAN port of a router.
2. Please use another RJ-45 Ethernet cable to connect one end to the LAN port on
the rear panel of the NVS-40 and then connect another end to one of the LAN port of
the router.
3. Please use another RJ-45 Ethernet cable to connect one end to the LAN port of the
PC/Laptop and then connect another end to the LAN port of a router.
4. Please open Datavideo IP Finder software and then please press the Scan button
to find the IP address of the NVS-40. (Please refer to Chapter 4. Quick Start Guide-
Connection and Setting)
5. Please enter NVS-40’s IP address into the address bar of the web browser to open
the web control interface of the NVS-40.
6. Please click the Streaming option from the web control interface to open the
streaming control interface.
7. Please select Main Encoder or Sub Encoder from the Encoder Source drop-down
menu.
8. Please select RTSP from the Stream Type drop-down menu of Main Encoder or
Sub Encoder.