18
3.
Press the LOAD SAVE button to start the copy process. The LOAD SAVE and the selected
camera button will be back lit orange and blinking.
4.
These buttons will be back lit green when copy process is completed.
4.3 How to save / load the camcorder settings to / from a PC
It is possible to save the current settings on all four cameras from MCU-200S to a PC for later use.
Also any previously saved MCU-200S settings stored on a PC can also be loaded back to the MCU-
200S unit. This can be handy if multiple users have access to the equipment and you need a quick
way to get back to your preferred settings.
Use the following procedure to save the current camera settings set by the MCU-200S unit to a PC.
1.
Power off the MCU-200S unit.
2.
Connect the MCU-200S unit to PC using USB cable via the USB 2.0 (Mini B) interface.
3.
Set the five switches
on the MCU-200S unit to their middle
position.
4.
Press and hold in both the CAM 1 & MU-1 buttons at same time and then power on the
MCU-200S unit.
5.
The seven segment LED Display will show “
cU--
”, and the PC will detect the MCU-200S unit
as an external storage device named “
MCU-200S_MUx
”.
6.
Open the “
MCU-200S_MUx
” folder on the PC and copy “
mu_param.bin
” file to desired PC
hard drive location.
7.
Once complete unplug the USB cable and reboot the MCU-200S unit.
To load previously saved settings on a PC to MCU-200S, repeat steps 1~5 of the above procedure
and then continue with the following steps.
6.
Open the “
MCU-200S_MUx
” file folder on PC and delete the “
mu_param.bin
” file.
7.
Copy the previously saved “
mu_param.bin
” file from the PC hard drive location to the
“
MCU-200S_MUx
” folder.
Note:
Do not worry if the previously saved
xxxxxxxxx.bin
file has been renamed on the PC. The
MCU-200S unit will automatically amend the file name back to “
mu_param.bin
” after a reboot.
8.
Once the copy process is complete unplug the USB cable and reboot the MCU-200S unit.
