11
Master Pedestal Control
These buttons are used to adjust the level of the Master Pedestal.
Enable & Painting Adjustment buttons
Press the ENABLE button in the
Painting area
of the MCU-100 before
choosing to adjust either the level of the Red and Blue Gain or the
RGB Pedestal values.
Mini B USB 2.0 port
This port is used for firmware updates or to save/transfer MCU-100
settings to computer.
See
page 15
for firmware update details.
See
page 14
for saving/transferring settings with a computer.
CHECK / Lock
GAIN value, SHUTTER speed, FILTER position, IRIS, Master
Pedestal, R/B Gain and RGB pedestal values are shown on the display
below in this order each time the CHECK button is pressed.
If the CHECK button is pressed and held down for over two seconds
the MCU-100 unit will switch in to LOCK mode. Please refer to
page
12
for more details on modes of operation.
LED display
The IRIS value, Shutter degree, speed, Gain and Filter positions can
be displayed here by using the CHECK button.
*The M. PED, PAINTING GAIN R/B and BLACK R/G/B values can also
be displayed sequentially here. See CHECK button also.
When in LOCK mode this display will show Lock.
EXT LED
This LED will be ON when a lens extender is detected on the chosen
camera.
IRIS control
Used to adjust the Iris value. See IRIS and CHECK buttons also.
IRIS button
To enable or disable Auto Iris.
The button is back lit orange when Auto Iris is enabled.
Summary of Contents for MCU-100
