Warning
Reconfiguring
NEVER reconfigure
the board
while
the power
is
ON.
If
you wish to reconfigure
the board at
any time,
make
sure that the power
is
tumed
OFF
before
changing any hardware
settings such as
DlP
switches
or
jumpers.
N019
-
When you
see
an
error
message on the screen
after turning
the power
on,
leave the system
switched on for
one
to two
hours
to
charge the
battery.
You
can then enter the system con-
figuration.
-
Later,
leave
your
system switched on
for 10 to
15
hours
to completely
charge the
battery.
-
It
you leave
the system switched
off
for more
than one
month,
repeat the steps above.
-
It
you
are using an onboard
battery,
be sure
pins
BATl'
and
INT (2
and
3)
of
jumper
W13
are shorted
when
you install your
system.
Otherwise, you
will
have
to
set
up your
con-
figuration
whenever
you turn on your computer.
Checklist
Your
PPM-20300 mainboard package contains the
following:
-
One PPM-20300 mainboard
-
One user’s manual
-
One
BIOS
system setup manual
-
One
EMS driver
diskette
Theifollowing does not apply
to
any country where such
provrswns
are inconsistent
with local law:
Datatechmakes
no
warranties
with
respect
to this
documentation
eitherexpress
or implied
and
provides
it
“as
is".
This includes but
is not limited to any implied
warranties
of merchantability
and
fitness
for
a
particular
purpose.,The
information
in
this
document
is
subject
to
change
without notice.
Datatech assumes
no
responsibility for any
errors that
may
appear
in
this
document.
All
brand
names are registered trademarks
of their
respective
companies.
Summary of Contents for Mini 80386SX
Page 1: ...o Mini 803863X 20MHz Mainboard User s Manual ...
Page 26: ......
