DSVII-SC
®
User Manual, Version 1.11
Copyright
©
2006 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
6
3
Initial Setup
•
Each unit is shipped with one Li-Ion battery installed, though disconnected. To enable the battery, you will need
to remove the rear cover and plug the battery connector into the mating connector on the DSVII-SC
®
.
•
The battery is shipped fully charged, however, there is a small amount of self-discharge even when the battery
is disconnected. It is
highly recommended
that you fully charge the internal battery before use to maximize
operating time before recharging is required. The unit will operate when connected via an external power
supply regardless of the state of the internal battery.
•
The DSVII-SC
®
contains an integrated charging circuit. No external charger for batteries is provided nor
required.
+
Please refer to Section 7, “Battery Charging and Replacement”, for additional instructions and safety
information.
4
Approved Uses
x
The DSVII-SC
®
is
NOT APPROVED
for use in any life-support capacity, or applications where lives may
be put at risk.
5
Third Party Software
The software packaged loaded into each DSVII-SC
®
may contain software modules (for example: WindowsCE.net-
4.2, fingerprint-matching algorithms, image-compression algorithms, etc.) which are licensed from 3
rd
-party
developers. These modules are licensed as-is. As such,
Datastrip
makes no representation, neither expressed nor
implied, about the reliability, performance or suitability of these licensed software components.