STEP 3 CONNECT MAINS CABLE
When the power is switched on the multi-display controller will boot and
the LEDs on the front panel will flash for up to 15 seconds. Should the LED’s
continue to flash see the troubleshooting section at the end of this guide.
STEP 4 CONNECTING TO A PC
To successfully configure your multi-display controller, firstly install the
Wall
Designer
application on your PC by downloading the latest version from the
Datapath website
www.datapath.co.uk
.
When the controller has booted, connect it to your PC using the USB cable
provided. The controller is a plug and play device. Wall Designer will detect it
when the layouts are configured.
The multi-display controller can also be configured via a Network, (see Step 5).
HDMI 1
HDMI 2
INPUTS
SYNC
IN
OUT
DISPLAYPORT
1
2
MONITOR OUTPUTS
LAN
USB
100-240V 1AMAX 50\60Hz
1A FUSE
MODEL 175
MADE IN ENGLAND
3
4
LOOP
HDMI 1
HDMI 2
INPUTS
SYNC
IN
OUT
DISPLAYPORT
1
2
MONITOR OUTPUTS
LAN
USB
100-240V 1AMAX 50\60Hz
1A FUSE
MODEL 175
MADE IN ENGLAND
3
4
LOOP
HDMI 1
HDMI 2
INPUTS
SYNC
IN
OUT
DISPLAYPORT
1
2
MONITOR OUTPUTS
LAN
USB
100-240V 1AMAX 50\60Hz
1A FUSE
MODEL 175
MADE IN ENGLAND
3
4
LOOP
HDMI 1
HDMI 2
INPUTS
SYNC
IN
OUT
DISPLAYPORT
1
2
MONITOR OUTPUTS
LAN
USB
100-240V 1AMAX 50\60Hz
1A FUSE
MODEL 175
MADE IN ENGLAND
3
4
LOOP
USP Port
Connect
Mains Cable
Switch on
5
x-Series Quick Start Guide
