Datamax OC2 BT, Technical Manual And User Manual

Page: 57 / 69

11
U
SING THE BELT CLIP
Using the belt clip
Install the belt clip as follows:
1. Turn the printer so that its back faces you and the belt clip
socket is up, as shown in Figure 27.
2. Place the belt clip over the belt clip socket such that the
flat side of the belt clip swivel matches the flat side of the
belt clip socket (Figure 28).
3. Press the belt clip onto the printer until the swivel is fully
seated into the socket.
4. Rotate the belt clip 180 degrees to lock it into place
(Figure 29 and Figure 30).
Reverse the above steps to remove the belt clip.
Using the control panel
The tables on the following pages document the following:
• Audio Indicators on page 12
• Battery Status LED on page 13
Figure27 Figure28
Belt clip socket
Belt clip swivel
Figure29
Figure30