20
I-Class
3.2 Media Sensor Adjustment
The Media Sensor needs to be positioned so that the printer can detect the
presence of media and the top-of-form (except for continuous stock, where the
TOF is set through programming; see Label Length, Section 4.1.2). To adjust:
n
With media loaded, as described in Section 3.1.1 or 3.1.2, grasp the Slide
Tab and move the Sensor Eye Mark into position over media according to
the table below.
o
If loading media, return to the media loading instructions.
Media Sensor Selection and Adjustment
Media Type
Sensor Eye Mark Position
Sensing Required
*
Die-cut
Near the middle of the label
Gap
Notched
Centered over the notch
Gap
Reflective
Centered over the black mark
Reflective
Continuous
Near the middle of the media
Continuous
*
See Section 4.1.2 for Sensor Type selection.
;
Note:
Changes to the start of print position can be made using the Print
Control/Row Adjust or Row Offset (see Section 4.1.3).
Summary of Contents for I-Class
