Creating Labels Using Internal Batch Software
40
Allegro2
3.3 Create/Modify Label Screen
This section describes how to create a new label. Before beginning,
a good tool to have on hand is a ruler marked in tenths of an inch
because all the label format print positions are specified in tenths
and hundredths of an inch. The procedure for creating a new label
is as follows:
1.
Power up the CRT terminal with the switch on the front of
the unit. Turn the Printer on with the Power Switch located
in the back of the Printer. The CRT screen will look like
this:
PRINT LABEL
MODULE NAME: ________________
LABEL NAME: ________________
QUANTITY: ________________
Figure 3-2 Print Label Screen Header
Press the F1 key, and the screen will look like this:
CREATE/MODIFY LABEL
MODULE NAME: ________________
LABEL NAME: ________________
ROT FNT XW XH BH
ROW
COL
TYPE
DATA/PROMPT
---
---
--
--
---
----
-----
----- ------------------------
Figure 3-3 Create/Modify Label Screen Header
Summary of Contents for Allegro 2
