Datalogic PowerScan Series, Product Reference Manual

Page: 66 / 411

ENTER/EXIT PROGRAMMING MODE RS-232/USB-COM INTERFACES
50
POWERSCAN™ PD/PM/PBT9600
RS-232/USB-COM SETTINGS
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and
the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec -
onds in 10ms increments. A setting of zero specifies no delay. See "
Intercharacter Delay"
on page 316
for more detailed programming instructions.
$CR2IC00
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
$CR2IC
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig -
its from the Alphanumeric characters in Appendix G
representing your desired character(s). End by scan -
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

00 = No Intercharacter Delay