Datalogic PowerScan RF, Programming Manual

Page: 109 / 220

RF Programming Manual
103
Start/Stop
Characters
Start/Stop Characters can be either Send or Don’t Send depending on
your host’s interface requirement. Refer to your host user’s manual to
identify your system requirements.
Start/Stop
Match
Start/Stop Match can be enabled or disabled.
Start/Stop
Format
Start/Stop Format can be set to one of four standard format options:
ABCD/TN*E, ABCD/ABCD, abcd/tn*e, or abcd/abcd. This setting
must match your system requirements. If you select one of these
options, it determines how the ASCII characters A, B, C, D (used for
Start/Stop characters) are translated before being sent to the host.
Read
Verification
Read Verification is the number of times the scanner is required to read
the bar code data before sending the label data to the host.
QuadraLogic
™ II
Decoding
QuadraLogic™ II Decoding directs the scanner to decode labels with
widespread problems of spots, voids, and/or non-uniform widths.
To optimize your scanner’s performance activate this option only for
symbologies for which it is necessary.
There are many additional ways to configure the scanner to read and
decode extremely poor labels. Contact your sales representative or ser-
vice provider for other advanced QuadraLogic™ II Decoding settings.
Configuring
the Codabar
Options
Use the special bar codes in this section to configure the Codabar sym-
bology options.
Codabar options are all applicable only to the scanner, with the
exception of the features for setting Check Digit Transmission
and Start/Stop Characters, which apply only to the Base Sta-
tion.
SET ------------------------------