Datalogic PD9330, Product Reference Manual

Page: 258 / 332

Enter/Exit Programming Mode
248 PowerScan™ PD9330/PBT9300/PM9300
Lower Case
This function enables/disables the capability to use the SHIFT key to switch
to Lower Case (alphanumeric) mode. When enabled, the indication in the
upper right corner of display is ‘ab’.
$CPWSA00\r
Disable Lower Case
DEFAULT
$CPWSA01\r
Enable Lower Case
SET FUNCTION KEY LABELS
Set F1 Label
This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
the Function Key below it.
$CPWSB
Set F1 label
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 8 digits from the
Appendix D, Key-
pad
. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code twice.
Set F2 Label
This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
the Function Key below it.
$CPWSC
Set F2 label
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 8 digits from the
Appendix D, Key-
pad
. The digits must be the hexadecimal ASCII represen-
tation of the desired characters.
End by scanning the ENTER/EXIT bar code twice.