Datalogic P2x-Series, Product Reference Manual

Page: 24 / 72

RAPID CONFIGURATION
16
P2X-SERIES™
(14 LEDs ILLUMINATOR) To remove and replace the internal illuminator
1. Remove the four lens cover screws and carefully remove the cover. See “To
remove the cover” on page 13.
2. Unscrew the four threaded spacers using the flat blade screw-driver, then remove
the illuminator.
3. Align the new illuminator with the camera case and gently press down until the
illuminator is tight to the case.
4. Tighten the four new illuminator threaded spacers. Maximum tightening torque
1.2 N m
5. Replace the cover screws. See “To replace the cover” on page 14.
(36 LEDs Illuminator) To remove and replace the internal illuminator
Two mounting options are available for the 36 LEDs Illuminator: vertical or landscape
position.
1. Place the camera on a flat-surface, such as the illuminator side faces downwards.
Remove the four illuminator screws and the illuminator.
2. Turn the camera case as the illuminator side faces upwards.
Align the new illuminator with the case and gently press down until the illumina-
tor is tight to the case.
3. Turn the camera upside down. Hold it firmly with both hands to be sure that the
illuminator stays with the case.
4. Replace the four illuminator screws. Maximum tightening torque 0.8 N m.
CAUTION
Keep the connector aligned to the contact.
NOTE
Configure an Internal Illuminator in VPM - Camera Setup (See “Startup” on
page 46.)
NOTE
Configure an Internal Illuminator in VPM - Camera Setup (See “Startup” on
page 46.)