MATRIX 450™ QUICK REFERENCE GUIDE
12
STEP 6 – X-PRESS™ CONFIGURATION
Once Matrix 450™ has calibrated image density, you can configure it for optimal code
reading relative to your application.
Locate
1. Enter the Focus function by pressing and holding the X-PRESS™ push button until the
Focus LED is on.
Figure 10 – X-PRESS™ Interface: Locate Function
2. Release the button to enter the Focus function. The Blue Diamonds™ and laser pointers
turn on.
3.
Select a code from your application
. Position the code at the center of the Horizontal
FOV (aligned with the laser pointers).
4. Exit the Focus function by pressing the X-PRESS™ push button once. The Blue
Diamonds™ and laser pointers turn off.
Setup
5. Enter the Setup function by pressing and holding the X-PRESS™ push button until the
Setup LED is on.
Figure 11 – X-PRESS™ Interface: Setup Function
6. Release the button to enter the Setup function. The Setup LED will blink until the
procedure is completed.
The Setup procedure ends when the Image Acquisition parameters are successfully saved
in the reader memory, the Setup LED will remain on continuously and Matrix 450™ emits
3 high pitched beeps.
If the calibration cannot be reached after a timeout of about 5 (five) seconds Matrix 450™
will exit without saving the parameters to memory, the Setup LED will not remain on
continuously but it will just stop blinking. In this case Matrix 450™ emits a long low pitched
beep.
7. Exit the Setup function by pressing the X-PRESS™ push button once.
READY
SETUP
FOCUS
TEST
LEARN
GOOD
TRIGGER
COM
STATUS
red yellow yellow green green
READY
SETUP
FOCUS
TEST
LEARN
GOOD
TRIGGER
COM
STATUS
red yellow yellow green green
