Datalogic Magellan 800i, Product Reference Manual

Page: 45 / 168

Enter/Exit Programming Mode
Product Reference Guide 37
ACK Character
NOTE
Sets the ACK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than
three digits with zeros, as in “005”. To configure this feature, scan the “Enter/Exit Programming Mode’ bar code above
to place the unit in Programming Mode, then the “Set ACK Character,” followed by the digits from the Alphanumeric
table in
Appendix C, Alphanumeric Pad
representing your desired character. Exit programming mode by again scanning
the “Enter/Exit Programming Mode’ bar code above.
DEFAULT SETTING FOR THIS FEATURE: 006
031F(CR)
Set ACK Character
Setting to previously defined characters
such as XON, XOFF, or host commands con-
flicts with normal operation of these char-
acters; 8-bit data is not recognized when
the Number of Data Bits = 7 ASCII charac-
ters or any hex value from 0 to FF.
NAK Character
NOTE
Sets the NAK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than
three digits with zeros, as in “005”. To configure this feature, scan the “Enter/Exit Programming Mode’ bar code above
to place the unit in Programming Mode, then the “Set NAK Character,” followed by the digits from the Alphanumeric
table in
Appendix C, Alphanumeric Pad
representing your desired character. Exit programming mode by again scanning
the “Enter/Exit Programming Mode’ bar code above.
DEFAULT SETTING FOR THIS FEATURE: 021
0320(CR)
Set NAK Character
Setting to previously defined characters
such as XON, XOFF, or host commands con-
flicts with normal operation of these char-
acters; 8-bit data is not recognized when
the Number of Data Bits = 7 ASCII charac-
ters or any hex value from 0 to FF.