Datalogic Magellan 3450VSi, Product Reference Manual

Page: 109 / 352

Global Prefix Enter/Exit Programming Mode
Product Reference Guide 99
Global Prefix/Suffix
Global Prefix
This feature applies to RS-232 interfaces (Standard, Wincor-Nixdorf, and Single
Cable). It specifies the prefix that is added to beginning of label transmission.
To specify the Global Prefix Character(s):
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code Set Global Prefix below. Cover any unused bar codes to
ensure the scanner reads only the bar code you intend to scan.
3. Scan the appropriate characters/digits from the Alpha-Numeric Keypad on
page 295 that represent the hex designation for the desired character(s).
The ASCII Character Set and their corresponding Hex Values are available
in the inside back cover of this manual. ASCII parameters must be input by
scanning a pair of hexadecimal digits for each character. Thus, to set a
two-character value of AB, bar codes containing the digits ‘4’, ‘1’, ‘4’, and
‘2’ must be scanned. The selectable range for this option is any hex value
from 00 to FF. Up to 20 hex pairs can be designated.
NOTE
To specify “No Global Prefix,” scan 00.
4. If designating the full 20 hex pairs, the scanner will exit Programming
Mode when the appropriate amount of digits have been scanned. If desig-
nating less than 20 hex pairs, you can end the programming sequence
early by scanning the Terminate Sequence bar code.
5. Complete the programming sequence by scanning the Enter/Exit Pro-
gramming Mode bar code.
031D(CR)
Set Global Prefix
00000(CR)
Terminate Sequence
DEFAULT
Default setting for this feature is:
00 - No Global Prefix