16
MAGELLAN™ 3410VSI
PROGRAMMING
Upon completing the physical connection between the scanner and its
host, proceed directly to the Programming Bar Codes table below to
locate the interface type the scanner is connected to (for example: RS-
232, USB, etc.).
Use the Bar Code Mask at the back of this manual to isolate the bar code
you intend to scan. Scan a START/END bar code once to enter
Programming Mode. After scanning the programming label for the
desired interface, scan the START/END barcode a second time to accept
your changes, exit Programming Mode and return the scanner to
normal operation.
Select other options and customize your scanner with programming
barcodes available in the PRG, or use the Datalogic Scanalyzer utility
available on the Datalogic website.
Interface Selection
NOTE: In the following sections, text shown with a green
star indicates a factory default value.
This is an example of a default value.
START / END
PROGRAMMING BAR CODES
RS-232 Standard
RS-232 Wincor-Nixdorf
000105(CR)
000112(CR)
