Datalogic Gryphon BT4100, Product Reference Manual, Page: 27 / 370

Configuring the Base Station
Product Reference Guide 25
Figure 12. Disconnecting the Cable
Insert
Paper Clip
Connecting the Base when Security Pin is Enabled
When connecting the Base to a system that has a custom Security Pin enabled, follow the steps
below in the order shown:
1. Power down the host system.
2. Connect the appropriate interface cable into the Base as shown in Figure 11 on page 24 .
3. Place the reader in the Base.
4. Power up the host. The reader will link to the Base.
5. When the host completely powers up, a new custom Security Pin Code may be sent to the
reader and Base, depending on host configuration. Contact Datalogic Technical Support for
more information.
To change security settings or set up a PIN, see
BT Security Mode, starting on page
280
.
Linking the Reader to a Base Station
RF Devices
For RF devices, before configuring the interface it is necessary to link the handheld with the
base. To link the handheld and the base, press the trigger to wake it and place it on the base. If
the reader was previously linked to another base, you must first scan the Unlink action
command before re-linking to the new base.
Unlink