Datalogic E1 Series, Hardware Manual

Page: 30 / 120

Safety Precautions MX-E Series Hardware Guide
Datalogic S.r.l. 24
NOTE : We recommend that you do not use a switch or a router between the MX-E Series Processor and the camera.
•
This camera is designed for indoor use. Do not expose it to moisture, including rain or snow, and avoid operating it in
wet areas. Should the camera become wet, turn off the power immediately. Moisture can damage the camera and create
danger of electric shock. Avoid using the camera when the humidity is above 80%.
• Make sure your camera has enough airflow around it for proper ventilation. The safe case temperature during operation
is from 0° to 50° C (32° to 122° F).
•
Mount the camera body in a fixed position where it will not be subject to excessive vibration.
• To reduce stress on the camera connectors and cable, loop the cables and fasten them to the camera's mounting block.
Do not crimp or tie the cables tightly with wire ties as this may damage them internally. The minimum cable bend
radius is fifteen times the cable diameter. It is not intended for continuous flexing or movement. Be sure that cables are
safely routed away from vehicle and pedestrian traffic.
•
Check the intended installation area to be sure there is enough room for the camera and any lighting that may be
needed.
• Avoid areas with excessive heat, vibration, and environmental contaminants.
•
Mount the camera away from devices that emit large amounts of electromagnetic energy.
• Do NOT attempt to clean the camera imager or imager cover. Do NOT spray the imager or imager cover with com-
pressed air as this may leave spots.
•
Do not leave the camera imager uncovered. When you remove the lens cap, you must replace it with a lens.