LED Indicators
Communication
The DL-Axist single slot dock supports USB 2.0 high speed interface. Using a standard USB (type A to
B) cable, you can connect the dock to a host device and transfer data.
1.
Connect power to the dock. Use country specific power cord. Refer to the Datalogic website.
2.
Plug the USB cable into the USB port on the back of the dock.
3.
Connect the other end of the USB cable to the USB port of the host device.
4.
Insert the DL-Axist into the dock.
Technical Specifications
FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
LED
Status
Power On
Solid Green
Dock is powered.
Spare Battery Charge
Solid Red
Spare Battery is charging.
Solid Green
Charging complete.
Power
Cord
Power
Supply
Host PC
DL-Axist
A to B USB cable
Single Slot Dock
Electrical Features
Consumption
1
1. Use only DL approved power adapters.
2.2 - 2.3 A
Indicators
Power on LED (green); spare battery charge LED (bicolored)
Charge Time
Standard battery: 4 hours; extended battery: 8 hours
Communication Features
Interface
USB 2.0
Baud Rate
480 Mbps for USB 2.0
Environmental Features
Working Temperature
2
2. Spare batteries should be charged at an ambient temperature between 0 - 35º C to achieve the maximum
charging rate. Charging is allowed in the battery temperature range 0-45°C. Never charge the main device
or spare batteries in a closed space (cabinet) where excessive heat can build up.
-20°C to 50°C (-4°F to 122°F)
Storage Temperature
-30°C to 70°C (-22°F to 158°F)
Humidity
90%
Mechanical Features
Dimensions
126 x 134 x 62 mm / 4.96 x 5.28 x 2.44 in
Weight
about 405 g / 14 oz
©2016-2017 Datalogic S.p.A. and/or its affiliates • All rights reserved. •
Datalogic and the Datalogic logo are registered trademarks of Datalogic S.p.A. in
many countries, including the U.S.A. and the E.U. DL-Axist is a trademark of
Datalogic S.p.A. and/or its affiliates. All other trademarks and brands are
property of their respective owners.
