Datalogic AV7000, Product Reference Manual

Page: 210 / 352

E-GENIUS
196
AV7000 LINEAR CAMERA
Modify Settings | Device Settings | <Camera Name> | Serial Port
Use the Serial Port menu tree selections to set up communications through the serial
Port. If necessary, you can later make modifications to the device settings using the
same menu selections, including:
• “Serial Port | Focus Port” on page 196
• “Serial Port | Host Port” on page 197
• “Serial Port | Aux Port” on page 198
Serial Port | Focus Port
Use the Focus Port window to configure communication between the barcode reader
and the focusing device. The focus port is only used to match the focus device’s commu-
nication configuration (light curtain, S-80, DM3610).
To edit the Focus Port settings:
1. In the menu tree under Modify Settings, navigate to
Modify Settings | Device Set-
tings | Camera N | Serial Ports | Focus Port.
The Focus Port window opens.
2. Enter the appropriate information in the form as described below:
Use Global Configuration
Select the check box when using a serial focus device for one or more cameras.
Baud Rate
Select a value from 1200 to 115200 from the drop-down list. Baud Rate is the transmission
speed in a communication line.
Data Bits
Select 7 or 8 from the drop-down list. Data Bits is a parameter indicating the number of bits
composing the data packet of the communication protocol frame.
Parity
Select None, Odd, or Even from the drop-down list. Parity is a parameter indicating the
presence of a control bit in the communication protocol frame.
Stop Bits
Select 1 or 2 from the drop-down list. Stop Bits is a parameter indicating the number of stop
bits in the data packet of the communication protocol frame.
Serial Communication Type
Select RS422 Full Duplex or RS232 from the drop-down list.
3. When you have finished making changes, click
Update
to save or click
Reset
to
revert to the previously saved values.
The Rangefinder does not use serial focus.