VS-1212-F and VS-1224-F Data Access Switches
10
© 2012 Datacom Systems Inc
NOTE:
For PCs without 9-pin serial ports, check with you product representative for available
sources of a USB to RS-232 Plug-in Adapter.
Step 2.
Using a supplied AC Line Cord, plug the VS-1212-F Data Access Switch or VS-1224-F
Data Access Switch into the external power source. Note that either
POWER 1
or
POWER 2
LED
is illuminated
green
indicating power is available at the rear AC power socket to which the AC Line
Cord is connected. The other
POWER
LED is illuminated
red
indicating a lack of power to the
unconnected AC power socket. Depress the AC power switch bar icon to power
ON
the VS-
1212-F or VS-1224-F which is indicated by the internal cooling fans powering up.
Step 3.
Open the terminal emulation application on your PC and configure the
SERIAL COM
Properties:
115,200 bits per second; 8 data bits; parity none; 1 stop bit and flow control none.
Step 4.
Hitting the
Enter
key twice in a row (i.e.,
Enter
,
Enter
) establishes a connection, displays
the
Command shell
prompt, then type
?
and press
Enter
to see a list of available commands.
Step 5.
Set the IP address by typing SET IP xxx.xxx.xxx.xxx where xxx.xxx.xxx.xxx corresponds
to a valid IP address for your network. Press the
Enter
key to continue.
Step 6.
Set the default gateway (if needed) by typing SET GATEWAY xxx.xxx.xxx.xxx where xxx.
xxx.xxx.xxx corresponds to your network's default gateway. Press the
Enter
key to continue.
Step 7.
Set the subnet mask by typing SET SUBNET xxx.xxx.xxx.xxx where xxx.xxx.xxx.xxx
corresponds to your network's subnet mask. Press the
Enter
key to continue.
Step 8.
Type EXIT to save the network address changes and press the
Enter
key to end the
connection session indicated by 'Connection closed' response.
Step 9.
Hit the
Enter
key twice in succession (i.e.,
Enter
,
Enter
) to establish another connection
session with the VS-1212-F or VS-1224-F, type SHOW and press the
Enter
key to review the
network address settings. Verify that the settings are correct.
Step 10.
Type EXIT and press the
Enter
key to end the connection session indicated by
'Connection closed' response. Then close the HyperTerminal window responding 'Yes' to the "You
are currently connect. Are you sure you want to disconnect now?' prompt.
