Datacolor CONDITIONER™ (MB2) 06/2017
page 20/126
Permissible ambient temperature range during transport:
•
If the steam humidifying system has NOT been emptied: +3 °C /
37.4 °F
to +60 °C /
140 °F
.
•
After your local Datacolor service representative has emptied the steam humidifying system: -10 °C /
14 °F
to +60 °C /
140 °F
.
At temperatures below +3 °C /
37.4 °F
, water must be completely removed from the humidifying system.
CAUTION
Transport below +3 °C / 37.4 °F with filled steam humidifying system.
Freezing in the steam generator.
Damage to the cabinet.
Contact your local Datacolor service representative before any transportation below +3
°C /
37.4 °F
.
3.3 Storage
Intermediate storage of the cabinet is possible in a closed and dry room. Observe the guidelines for tem-
porary decommissioning (chap. 21.2).
Permissible ambient temperature range during storage:
•
If the steam humidifying system has NOT been emptied: +3 °C /
37.4 °F
to +60 °C /
140 °F
.
•
After your local Datacolor service representative has emptied the steam humidifying system: -10 °C /
14 °F
to +60 °C /
140 °F
With temperatures below +3 °C /
37.4 °F
, water must be completely removed from the humidifying sys-
tem.
CAUTION
Storage below +3 °C / 37.4 °F with filled steam humidifying system.
Freezing in the steam generator.
Damage to the cabinet.
Contact your local Datacolor service representative before any transportation below +3
°C /
37.4 °F
.
Permissible ambient humidity:
max. 70 % r.H., non-condensing
CAUTION
Condensation by excess humidity.
Danger of corrosion on the housing after operating at humidity values > 70 % r.H.
for a long period.
Dry the cabinet completely before shut-down:
•
Set the humidity to 0 % r.H. To enable dehumidification, the humidifying and dehu-
midifying system must be activated (deactivated operation line “Humidity off”, chap.
7.3 and setting “Control on”, chap. 6.3).
•
Set the temperature set point to 60 °C /
140 °F
for approx. 2 hours (Manual mode).
•
Only then, shut down the cabinet at the main power switch (1) and close the tap of
the water supply.
When after storage in a cold location you transfer the cabinet to its warmer installation site, condensation
may form. Before start-up, wait at least one hour until the cabinet has attained ambient temperature and
is completely dry.
