Data Translation DT3130 Series, Getting Started Manual

Page: 42 / 54

Chapter 4
34
Note:
The strobe wiring for the DT3131, DT3132, and DT3133 is
compatible with standard EG&G strobe inputs. The strobe wiring
for the isolated boards (DT3131-ISO, DT3132-ISO, and
DT3133-ISO) is not compatible with EG&G strobe inputs. Refer to
the
DT3130 Series User’s Manual for information on how the
strobes work for the isolated and nonisolated boards.
4. If you want the DT3130 Series board to p12 V (1.5 A)
power to a strobe or camera, perform the following steps:
a.
Attach the +12 V input signal to connector J2 of the EP312, if
you are powering a strobe, or to connector J5 of the EP312
cable, if you are powering a camera.
Table 2 describes the
connectors and pins of the EP312 cable.
b.
Using an EP315 cable, connect the P1 connector of the cable
to the +12 V power plug inside your computer, as shown in
Figure 8 .
Table 2: +12 V Power Signal Connections
Signal Name EP312 Connector Connector Pin
+12 V Strobe 0 1
+12 V Return Strobe 0 6
+12 V Trigger 4
+12 V Return Trigger 9