Data Translation DT3130 Series, Getting Started Manual

Page: 19 / 54

Preparing to Use the DT3130 Series
11
2
2
2
2
2
2
2
2
2
Installing the Software
To operate properly, the DT3130 Series board requires the following
software components:
• Microsoft DirectX, version 7.0 or greater,
• DT-Acquire, version 3.2 or greater, and
• Frame Grabber SDK, version 3.0 or greater.
You can install these software components from the Imaging OMNI
CD. To install the DT3130 Series-related software from the Imaging
OMNI CD, perform the following procedure:
1. Insert the Imaging OMNI CD into your CD-ROM drive.
Note that in most systems, the CD will launch automatically. If
your system does not launch the OMNI CD automatically,
perform the following steps:
a. Click Start from the Task Bar, then click Run .
The Run dialog box appears .
b. Either enter x :\LAUNCH.EXE (where x is the letter of your
CD-ROM drive) or use the Browse button to locate
LAUNCH.EXE.
c. Click OK .
The Imaging OMNI CD splash screen appears.
2. Click Install Products .
3. Click Device Drivers .
4. Click Mach I Series .
5. Click DT3130 Series .
The InstallShield Wizard appears.
6. Click Next .