FLC910E User’s Guide
PN 161-09856-001A
June 2010
Select the Network Authentication and Data Encryption that is the same as the base station to associate with.
Authentication Types / Options
Open System
None, WEP64, WEP128, and WEP152
Shared Key
WEP64, WEP128, and WEP152
WPA-PSK
TKIP
WPA2-PSK
AES
Apply the settings.
The “Station Adaptor” should be connected to the “Base Station” and the RSSI LEDs on the top should indicate the signal
strength.
Wireless Repeater:
The FLC910E can operate as a “Wireless Repeater” to repeat “Base Station” or other “Wireless Repeaters” to extend the
area of the wireless network coverage. “Station Adaptors” can connect to the “Wireless Repeater”.
This unit will be setup similar to the “Base Station” since this device operates as a “Base Station” with repeating or WDS
operation. The security profile for BS_profile1 (or as many that are Enabled) and the wds_profile are active.
To setup the “Wireless Repeater” select “Wireless Repeater” from the drop down menu of “Operating Mode”.
Apply this setting; the unit will be in “Wireless Repeater” mode.
Select the type of modulation OFDM or CCK.
Select the data rate to use.
Note:
Best will try to establish the highest possible data rate, but for longer distances using a fixed lower rate may
improve system reliability.
Select the output power, from full – min depending on distance.
Select the bandwidth to use. The bandwidth selected will determine the usable channels / frequency.
Select the Channel to use based on the table below:
Bandwidth / Channels Available
20 MHz
CH2 or CH3
10 MHz
CH1, CH2, CH3, or CH4
5 MHz
CH1, CH2, CH3, or CH4
Apply the setting changes, if any.
Select the Edit next to Base Station ID, this will go to the VBS / VLAN Settings menu page.
Select the Profile and click the edit button.
Choose the SSID and Network Authentication settings for the network. For the network to repeat use the wds_profile for
the encryption settings.
Summary of Contents for FLC910E
Page 2: ...Notes ...
