Darwin Fitness DF-SC40, Assembly And Operating Instructions Manual

Page: 22 / 36

EVO40
22
5 TROUBLESHOOTING, CARE AND MAINTENANCE
5.1 General Instructions
⚠
WARNING
+ Do not make any improper changes to the equipment.
⚠ CAUTION
+ Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary, use
only original spare parts.
࣑ ATTENTION
+ In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
5.2 Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common errors and
how to correct them. If the equipment still does not function properly, contact your contract partner.
Fault Cause Solution
Crackling noise in
pedal area
Loose pedals Tighten the pedals
Equipment wobbles Equipment is not level Adjust the supporting feet
Handlebar/saddle
wobbles
Screws are loose Tighten screws
Display does not turn
on
Battery is low or the cable
connection is loose
Change batteries or check
cable connections
No pulse display
+ Sources of interference in
the room
+ Unsuitable chest strap
+ Position of the chest
strap incorrect
+ Batteries empty
+ Check if heart rate can
be detected via the hand
pulse sensors
+ Remove sources of interference (e.
g. mobile phone, speakers, WLAN,
mover- and cleaning robot, etc.)
+ Use suitable chest strap (see
recommended accessories)
+ Reposition chest strap and/or
moisten electrodes
+ Change batteries