DARAY X200, Operating & Installation Manual

Page: 11 / 28

Page 10 of 22
4.1.2 Placement and Installation
The power supply for the X200 is a plug top transformer with a DC jack connection,
these can be inserted into any standard UK wall socket.
Please note, under no circumstances should this product be connected
directly to the Mains electrical supply, this product requires a Low
Voltage Connection only and must only be used with a Daray Certified
Power Adapter.
• Remove the light from its packaging.
• Mark on the wall the selected location for the
wall-mounting bracket, bearing in mind the final
position of the light head required to project its
light-patch where it will be needed.
We recommend 850-1100mm from the floor to the
underside of the bracket – dependent on couch
height. Ideally, the underside of the bracket should
be 150-200mm above the couch.
•
Taking note of the considerations in section 4.1.1,
mount the PIVOTW2 wall bracket directly to the
wall. Use a spirit level to ensure the bracket is on a
true vertical plane.
• Once the bracket is installed, turn the
thumbscrew anti-clockwise to allow a clear path
through the hole, and then slide the light spigot
directly into the hole in the bracket. Make sure the
light is fully pushed in.
• Tighten the thumbscrew to secure the light in
position.