PCI-DIO02 User’s Manual
16
(1)
„Model No‟ Button
It selects the motel name PCI-DIO02.
(2)
„Board No‟ Button
It selects the selected board number (Board # 0 ~ Board # 3) when clicked. The board number
can be set to SW1 in the board and connect up to 4 units.
(3)
„Open Device‟ Button
It opens the selected board.
(4)
„Exit‟ Button
Exit the program. The set values are initialized and terminated.
Window exit is not initialized.
(5)
„List Device‟ Button
It displays the board numbers installed in the System. (Unused state)
(6)
„Direction‟ Button
It selects Read / Write mode. 16bit units can be selected in one group.
Each group
'IN' : Read
'OUT' : Write
For example)
When [Bit0..15] is set to OUT as shown in [Figure 5], group 0 is set to write mode.
When [Bit127..112] is set to OUT as shown in [Figure 5], group 7 is set to write mode.
When you read "Read" in this state, you can see that it is set to
"81".
"FF" [Bit127..0]
All 7 groups are set to write mode.
(7)
„Digital Input‟ Window
It check the corresponding bit (16bit) value for each group. It displays the input value of the
group when Read button is clicked.
'Auto DIN Read'
check can be checked immediately when input is picked up.
'Read All'
checks the input of all groups.
(8)
„Digital Output‟ Window
Check the corresponding bit (16bit) output value for each group.
When the
'Read'
button is clicked, the value set to 'Write' is displayed.
When the
'Write'
button is clicked, the corresponding bit of the port is set to the write mode.
You can use 16 output ports by writing "ffff" bit (15..0) in Digital Output window in [Figure 5]
above.
When
„Auto DOUT Test‟
is
checked, "0" is written while shifting data one bit to the left
sequentially for the group set as Output.
