7
Transmitter
Fig. 3
10)
Power On/ Mute/ Off switch
Pushing the button switches the transmitter on, the
power on (12)
LED lights up green. Pushing and
holding the button for three seconds will turn the transmitter off, the
power on (12)
LED will dim.
11) Reset button
12)
Power on LED
Indicates the status of the transmitter. Lights up continuously when switched on, dims when switched off
and lights up red to indicate a weak battery.
13) Mic/line input
Unbalanced mono 3,5mm jack input. The input is
not
able to provide phantom power!
14)
Input gain trimmer
Use a small screwdriver (included) to adjust the input level.
15)
Channel button
Push and hold the button for 3 seconds. Now the point in the display will start blinking. Tapping the button
allows you to set the receiving channel. As the button is released for at least 6 seconds, the channel will
be stored. Be aware that when you several WCA Pack systems at the same stage, that the channels
should be separated by at least 4 channels.
16)
Input gain trimmer
Use a small screwdriver (included) to adjust the input level.
17)
Belt clip
18) Built in microphone
19) Charge connector
Summary of Contents for WCA Pack
Page 17: ......