DAPAudio T-5000, Manual

Page: 13 / 18

11
1. Channel fader - Controls the individual source levels in the mix.
2. Input toggle switch - Selects which source will be active, depending on what you have connected to
the rear panel input section.
3. Treble and Bass EQ - Adjusts the high and low frequency levels of the input channels for good sound.
4. Channel Gain - Adjusts the pre-fader volume for cleaner sound.
5. Replaceable Crossfader - Achieves clean crossing between the two input channels. "Hard left" selects
Channel 1. "Hard right" selects Channel 2. With the crossfader centered, both assigned channels are
live. Use the crossfader for fast and seamless crossing from one selected channel to the other.
Note: The crossfader is user replaceable in case of failure. Simply unscrew the two large screws, which
hold it in place, lift it out and disconnect its cable. Re-attach the new crossfader and screw the mounting
plate back onto the unit - you’re back in business!
6. Mic Input Gain - Adjusts microphone level.
7. Mic Input - Insert your Microphone with 1/4” plug in here.
8. Headphone Input - Insert in the 1/4” plug for your headphones here.
9. Channel Cue - Used to preview channel audio to your headphones. Listen here before bringing up
channel faders or moving the crossfader.
10. Headphone Level - Adjusts cue volume.
11. Master Fader - Controls the overall output level.
DESCRIPTION MIXER REAR PANEL:
AC 9V
ON OFF
16 17 15 14 12 13 14 12 13
Fig. 5
12. Phono Inputs - these connectors are used, your signal is fed directly to the high-quality RIAA phono
pre-amplifiers. Use this position only for turntables. Line level sources will overload the sensitive phono
pre-amps and will cause distortion.
13. Ground - Grounding nut for turntable connection. Always use this connection when using turntables.
(your turntable cable should have a grounding wire)
14. Line Inputs - Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD
players, HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, laser discs, tuners, even
synthesizers or other mixing consoles.
NOTE: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector.
15. Stereo Main Outputs - Unbalanced RCA connectors controlled by the Master fader.
16. Power Connector - Plug in power adapter here and check the voltage level to match your country’s
standard.
17. Power Switch - turn the unit off and on with this switch.