DAPAudio Stageamp 2.2, User Manual

Page: 9 / 21

7
Backpanel
Fig. 3
14. Power Fuse (18AL / 250V)
Replace the fuse only by a fuse of the same type.
15. Air cooling
Make sure these outlets remain clear to allow unrestricted air flow.
16. lnput sensitivity selector
The switch has three exchange modes:
1) Whole equipment signal gain is 26dB
CH1
CH2
2) Whole equipment signal gain is 32dB
CH1
CH2
3) Whole equipment signal gain is 38dB
CH1
CH2
17. Balanced Link Out connectors.
Used to Link the input signals to other amplifiers.
18. Balanced XLR Input Connectors.
These connectors accept input signals on XLR input plugs, See the section on connecting cables on
page 13 for more information on polarity. Connectors for each channel are in parallel, the unused
connectors may be used for linking to other amplifiers.
19. CH1 Binding post output
In stereo or parallel mode, connect the negative wire of your speaker to the black binding post
and the positive wire of your speaker to the red binding post.
In bridge mode, only connect the
speaker wires to the red binding post of Channel 1 and Channel 2.
20. CH1 SPEAKON output
In stereo or parallel mode, connect the negative wire of your speaker to the -1 pin and connect
the positive wire of your speaker to the +1 pin of the speakon connector.
In bridge mode, connect the
speaker wires to the +1 and the +2 pins of the speakon connector.
21. Power cord
Plug this cord into the power supply socket. (Before using the power amplifier, check if the power
supply is 240V).