5
Fig. 2
15)
AC Input 230V
16)
AC Power Selector: 100V-120V / 220V-240V may only be changed by the manufacturer.
17)
Ground (GND) screw
18)
Line Out: This output terminal sends the complete mixed signal of all sources to eg. another amplifier or
a recorder.
19)
Aux Input: To connect another Line-level device eg. mixer, recorder, tuner.
20)
Output terminals: connect to the speakers
Installation
PA100CD Installation
Remove all packing materials. Check that all foam and plastic padding has been removed. If you want to
use the amplifier in a 19” Rack, you must first install the 19” flaps. Then screw the amplifier/CD player in a
19“ Rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Do not supply power before
all components of the system are
set up and connected properly.
Input Connection
Microphones
The PA100CD is equipped with 3 inputs. They can be used with unbalanced low impedance devices
MIC-1, MIC-2, MIC-3
These three microphone inputs are unbalanced type and are provided with a double pole phone jack.
Balanced LO Z Microphone
May also be connected to the unbalanced input
We advise you to use FL0215, FL023 or FL026 unbalanced mic cables from Dap Audio
Summary of Contents for PA100CD
Page 1: ...PA100CD ORDERCODE D6111...
Page 12: ...10 Set Up Example 1 Fig 4...
Page 17: ...2005 DapAudio...
