DAPAudio IMIX-7.1, Manual

Page: 8 / 16

7
IMIX 7.1
Ordercode: D2350
Functions
1. Mic input connector
Electronically balanced combo-type input for
connecting low impedance microphones. The input has
extremely low noise and low hum. When connecting a
microphone make sure that the pin assignment is
correct. Always make sure to read the manual of the
microphone you want to connect. The XLR- input is not
suitable for connecting an additional mixing console, FX-
unit, etc. You have to use the
line (48-52) inputs, when
connecting this kind of equipment.
Note: When connecting signal sources, please make
sure the corresponding channel faders and the master
faders are at their minimum settings. Otherwise
unpleasant plug-in noise can occur.
2.
Peak LED
The Peak LED shows peak levels in a channel’s incoming
signal level. If the peak LED frequently blinks or constantly
lights, the corresponding channel is likely to enter
clipping and you have to reduce the input’s
amplification using the
level (8) control. The peak LED
lights at a level of 8 dB below clipping. Make sure that
the peak LED
lights only briefly during dynamic peaks.
3/4/5. Equalizer section (high/mid/low)
The microphone channel’s equalizer section allows shaping of the incoming audio signal. All mono input
channels are fitted with 3-band EQ. The high (5) and low (3) shelving controls have their frequencies fixed
at 12KHz and 80Hz respectively. The mid (4) range control has a peaking response frequency at 1KHz. All
3 bands have up to 12dB cut and boost, with a centre detent for off. Turning an Equalizer control to the
right amplifies the frequency range, turning to the left attenuates the signal. Minor changes to the
Equalizer control usually produce the best results. Try to avoid excessive enhancement of the MID band.
6. Talkover on button
Use this switch to activate the talkover function.
7. Power LED
The green power LED lights when the Sessionmix is turned on. If after switching the device on, the LED
does not light, make sure that the AC adapter is connected properly. If the LED still doesn’t light up after
everything is connected right, please contact your DAP audio dealer.
8. MIC level control (Mic 1/2)
Controls the volume of the corresponding microphone channel.
9. Talkover amount control
Use this control to set the amount of signal reduction for the line channels 1-5 when spoken in the
Microphone. Use this control to set the amount of signal reduction for the line channels 1-5 when spoken
in the microphone.
10. Talkover time control
This control allows you to set the time for returning to the normal volume level of the line channels 1-5 if
you stop speaking in the microphone.
11. Mute button
Use this switch to mute the according Microphone channel.